Welcome to Purple Support

Teltonika RUT Series

  • Updated
NOTE: You will require firmware version R_00.07.00 or above in order to continue

Log in to your Teltonika web interface. At the top, click Network > Wireless. Click Add and configure with:

  • Enable wireless: Yes


Under Device Configuration

  • SSID: Guest WiFi (or whatever you wish)


Under Interface Configuration

  • Encryption: No encryption


Click Save. Next, at the top click Services > Hotspot. Click Edit beside your new SSID. Configure with:

 

On the General tab:

Under General Settings

  • Configuration profile: Custom
  • Enable: Yes
  • AP IP: Leave default
  • Logout IP: Leave default
  • Authentication mode: External radius
  • Authentication protocol: PAP
  • RADIUS server #1: *insert radius_server here*
  • RADIUS server #2: *insert radius_server2 here*
  • Authentication port: 1812
  • Accounting port: 1813
  • Radius secret key: *insert radius_secret here*
  • UAM port: Leave default
  • UAM UI port: Leave default
  • UAM secret: *insert uam_secret here*
  • NAS Identifier: guest
  • Swap octets: Yes
  • External Landing Page: Yes
  • Landing page address: *insert access_url here*
  • HTTPS redirect: No

 

Under Walled Garden

Click Add and configure with:

  • Enable: Yes
  • Address: *insert access_domain here*
  • Allow subdomains: Yes

 

Using the same procedure as above, add a new entry for the below domains:

  • venuewifi.com
  • cloudfront.net
  • openweathermap.org
  • stripe.com

 

If you wish to support social network logins, you also need to add the following domains for each network you plan to support

Facebook facebook.com
fbcdn.net
akamaihd.net
connect.facebook.net

X twitter.com
twimg.com

LinkedIn linkedin.com
licdn.com

Instagram instagram.com

Weibo weibo.com
sina.com.cn

VKontakte vk.me
vk.com

 

Click Save to apply.



Share online:
Was this article helpful?
0 out of 0 found this helpful