Welcome to Purple Support

Teltonika RUT Series

  • Updated
NOTE: You will require firmware version R_00.07.00 or above in order to continue

Log in to your Teltonika web interface. At the top, click Network > Wireless. Click Add and configure with:

  • Enable wireless: Yes


Under Device Configuration

  • SSID: Guest WiFi (or whatever you wish)


Under Interface Configuration

  • Encryption: No encryption


Click Save. Next, at the top click Services > Hotspot. Click Edit beside your new SSID. Configure with:

 

On the General tab:

Under General Settings

  • Configuration profile: Custom
  • Enable: Yes
  • AP IP: Leave default
  • Logout IP: Leave default
  • Authentication mode: External radius
  • Authentication protocol: PAP
  • RADIUS server #1: *insert radius_server here*
  • RADIUS server #2: *insert radius_server2 here*
  • Authentication port: 1812
  • Accounting port: 1813
  • Radius secret key: *insert radius_secret here*
  • UAM port: Leave default
  • UAM UI port: Leave default
  • UAM secret: *insert uam_secret here*
  • NAS Identifier: guest
  • Swap octets: Yes
  • External Landing Page: Yes
  • Landing page address: *insert access_url here*
  • HTTPS redirect: No

 

Under Walled Garden

Click Add and configure with:

  • Enable: Yes
  • Address: *insert access_domain here*
  • Allow subdomains: Yes

 

Using the same procedure as above, add a new entry for the below domains:

  • venuewifi.com
  • cloudfront.net
  • openweathermap.org
  • stripe.com

 

If you wish to support social network logins, you also need to add the following domains for each network you plan to support

Facebook facebook.com
fbcdn.net
akamaihd.net
connect.facebook.net

Twitter twitter.com
twimg.com

LinkedIn linkedin.com
licdn.com

Instagram instagram.com

Weibo weibo.com
sina.com.cn

VKontakte vk.me
vk.com

 

Click Save to apply.



Share online:
Was this article helpful?
0 out of 0 found this helpful