Welcome to Purple Support

Ligowave NFT/LigoDLB Series

  • Updated

IMPORTANT: You require firmware version 7.54-5 or above in order to proceed.


Log in to the Ligowave AP web interface and click Wireless Configuration on the left. Under Wireless settings (AP) click Add virtual AP. Configure as below:

  • SSID: Guest WiFi (or whatever you wish)
  • Broadcast SSID: Enabled
  • Security: Hotspot (UAM)

Under UAM settings -> RADIUS tab:

  • Primary server: *insert radius_server here*
  • Secondary server: *insert radius_server2 here*
  • Server secret: *insert radius_secret here*
  • Authentication port: 1812
  • Accounting port: 1813

Under Captive portal tab:

  • Splash page type: External
  • Portal secret: *insert uam_secret here*
  • Login URL: *insert access_url here*

Under Network tab:

  • Internal IP address:
  • Network mask:
  • DNS server 1:
  • DNS server 2:

Under White/Black list tab add the required domains to the white list. Please refer to this list.

Click Done to Save.


Finally, click Save at the top to apply settings.

Share online:
Was this article helpful?
0 out of 0 found this helpful