Welcome to Purple Support

Ligowave NFT/LigoDLB Series

  • Updated

IMPORTANT: You require firmware version 7.54-5 or above in order to proceed.

 

Log in to the Ligowave AP web interface and click Wireless Configuration on the left. Under Wireless settings (AP) click Add virtual AP. Configure as below:

  • SSID: Guest WiFi (or whatever you wish)
  • Broadcast SSID: Enabled
  • Security: Hotspot (UAM)

Under UAM settings -> RADIUS tab:

  • Primary server: *insert radius_server here*
  • Secondary server: *insert radius_server2 here*
  • Server secret: *insert radius_secret here*
  • Authentication port: 1812
  • Accounting port: 1813

Under Captive portal tab:

  • Splash page type: External
  • Portal secret: *insert uam_secret here*
  • Login URL: *insert access_url here*

Under Network tab:

  • Internal IP address: 10.1.0.1
  • Network mask: 255.255.255.0
  • DNS server 1: 8.8.8.8
  • DNS server 2: 8.8.4.4

Under White/Black list tab add the following to the white list:

  • *insert access_domain here*
  • cloudfront.net
  • venuewifi.com
  • stripe.com
  • openweathermap.org

Additionally. if you wish to support social network logins, you also need to add the domains below for each network you plan to support.

Facebook facebook.com
fbcdn.net
akamaihd.net
connect.facebook.net
Twitter twitter.com
twimg.com
LinkedIn linkedin.com
licdn.com
Instagram instagram.com
akamaihd.net
Weibo weibo.com
login.sina.com.cn
VKontakte vk.me
vk.com

 

Click Done to Save.

 

Finally, click Save at the top to apply settings.

Share online:
Was this article helpful?
0 out of 0 found this helpful