Please note: You need firmware version 3.5.4 or above to continue.
Log in to your Pepwave AP One web interface.
Click AP at the top and then New SSID. Configure with the following:
Under SSID Settings:
- Enable: Enabled (ticked)
- Radio Selection: 2.4GHz and 5GHz
- SSID: Guest WiFi (or whatever you wish)
- Broadcast SSID: Enabled (ticked)
Under Security Settings:
- Security Policy: Open (No Encryption)
Under Captive Portal:
- Captive Portal: Enable
- Authentication Method: RADIUS
- RADIUS Security: PAP
- Splash Page: *insert access_url here*
- Landing Page: Enabled (ticked)
- Landing Page URL: *insert redirect_url here*
- Profile MAC Address: LAN MAC Address
- Allowed Domains / IPs: Enter the following domains one per line:
venuewifi.com
openweathermap.org
cloudfront.net
stripe.com
If you wish to support social network logins, you also need to add the domains below for each network you plan to support
facebook.com fbcdn.net akamaihd.net connect.facebook.net |
twitter.com twimg.com |
linkedin.com licdn.net licdn.com |
instagram.com |
Under RADIUS Server Settings (Primary Server):
- Host: *insert radius_server_ip here*
- Secret: *insert radius_secret here*
- Authentication Port: 1812
- Accounting Port: 1813
Under RADIUS Server Settings (Secondary Server):
- Host: *insert radius_server2_ip here*
- Secret: *insert radius_secret here*
- Authentication Port: 1812
- Accounting Port: 1813
Under Guest Protect:
- Block LAN Access: Enabled (ticked)
Click Save to confirm.
At the top right, click Apply Changes to complete.