Start by logging into your Cisco WLC web interface.
Step 1 - RADIUS
Click Security at the top and then AAA > Radius Authentication on the left menu. Set the below setting then click Apply:
Click New at the top right and configure with:
Click Apply to save. Click New again and configure with:
Click Apply to save. Click Radius Accounting on the left menu. Set the below setting then click Apply:
Click >New at the top right and configure with:
Click Apply to save. Click New again and configure with:
Click Apply to save.
Step 2 - ACLs
Click Access Control Lists (or FlexConnect ACLs if you use FlexConnect) on the left and then New at the top right. Configure with:
Click Apply to save.
If you are using local AP's (not FlexConnect mode):
To the right of the ACL you just created, hover the blue arrow and click Add-Remove URL. In the URL String Name box add the following domains one at a time:
*insert access_domain here*
cloudfront.net
venuewifi.com
openweathermap.org
stripe.com
Facebook:
facebook.com
fbcdn.net
akamaihd.net
connect.facebook.net
Twitter:
twitter.com
twimg.com
LinkedIn:
linkedin.com
licdn.net
licdn.com
Instagram:
instagram.com
OR if you are using FlexConnect mode:
Click in to the ACL you just created, then click Add Rule > URL rule at the top right. In the URL box add the following domains one at a time, ensuring you set the Action to Permit each time:
*insert access_domain here*
cloudfront.net
venuewifi.com
openweathermap.org
stripe.com
Facebook:
facebook.com
fbcdn.net
akamaihd.net
connect.facebook.net
Twitter:
twitter.com
twimg.com
LinkedIn:
linkedin.com
licdn.net
licdn.com
Instagram:
instagram.com
Click Web Auth > Web Login Page on the left and configure with:
Click Apply to save.
Step 3 - WLAN
Click WLANs at the top and then WLANs on the left. Click Create New > Go at the top right (or edit and existing WLAN if you have one already). If creating a new WLAN, configure with:
Click Apply to save. Next, click the SSID profile to edit the settings.
On the General tab:
On the Security > Layer 2 tab:
On the Security > Layer 3 tab:
On the Security > AAA Servers tab:
On the Advanced tab:
Click Apply to save. Next, click Management at the top then HTTP-HTTPS on the left. Configure with:
Click Controller at the top then Interfaces on the left. Configure with:
Click Apply to save.
Finally, be sure to click Save Configuration at the top right.
The configuration is now complete.