Welcome to Purple Support

Configure BLE on Aruba Networks APs

  • Updated

To configure Bluetooth Low Energy (BLE) on Aruba Networks Access Points, you need to perform the following steps:

1. Connect to the Access Point using SSH or a web browser.

2. Enter the appropriate credentials (username and password) to log in to the Access Point's management interface.

3. Once logged in, navigate to the configuration settings for the Access Point. Look for the option to enable BLE and make sure it is enabled.

4. Configure the specific settings for BLE, such as the advertising interval, transmit power, and other parameters. These settings may vary depending on the Access Point model and firmware version. Refer to the documentation or user guide provided by Aruba Networks for detailed instructions on configuring BLE settings.

5. After configuring the BLE settings, save the changes and apply them to the Access Point.

6. Once the configuration is applied, verify that BLE is functioning correctly on the Access Point. You can use a BLE-enabled device (e.g., smartphone, tablet) to scan for nearby BLE devices, or connect to the Access Point using a BLE console application.

 

It's important to note that the specific steps and options for configuring BLE on Aruba Networks Access Points may vary depending on the model and firmware version. Always refer to the official documentation or consult Aruba Networks support for detailed and up-to-date instructions tailored to your specific equipment.

Share online:
Was this article helpful?
0 out of 1 found this helpful