Important
Supported models and firmware versions:
- WAP125: 1.0.1.7 or above
- WAP150: 1.1.2.4 or above
- WAP361: 1.1.2.4 or above
- WAP571: 1.1.0.3 or above
- WAP581: 1.0.1.5 or above
Logging in
Start by logging into your Cisco WAP web interface.
Guest Access
Click Access Control > Guest Access on the left menu. Configure with:
| Enable: | Yes |
| Guest Access Instance: | guestwifi |
| Protocol: | HTTP (80) |
| Authentication Method: | External Captive Portal |
| Guest Group: | Default |
| Session Timeout: | 1440 |
Press Apply to Save.
Beside the Authentication Method option, click the eye icon to edit. Configure with:
| Splash Page URL: | *insert access_url here* |
| Walled Garden: | Please refer to this list. |
| Server IP Address-1: | *insert radius_server_ip here* |
| Server IP Address-2: | *insert radius_server2_ip here* |
| Key-1: | *insert radius_secret here* |
| Key-2: | *insert radius_secret here* |
| RADIUS Accounting: | Enable |
Click Ok to Save.
Important
Note: Check the Protocol setting is still set to HTTP (80) and not HTTPS (443). Click Apply again to Save.
Wireless
Click Wireless > Networks on the left menu and on the Radio 1 tab click the Plus icon. Configure with the below settings:
| VLAN ID: | 1 (or whatever you need) |
| SSID Name: | Guest WiFi (or whatever you wish) |
| SSID Broadcast: | Enabled |