Bienvenido a Soporte Purple

Pepwave AP One Series

  • Actualización

Please note: You need firmware version 3.5.4 or above to continue.

 

Log in to your Pepwave AP One web interface.

Click AP at the top and then New SSID. Configure with the following:

Under SSID Settings:

  • Enable: Enabled (ticked)
  • Radio Selection: 2.4GHz and 5GHz
  • SSID: Guest WiFi (or whatever you wish)
  • Broadcast SSID: Enabled (ticked)
Under Security Settings:
  • Security Policy: Open (No Encryption)
Under Captive Portal:
  • Captive Portal: Enable
  • Authentication Method: RADIUS
  • RADIUS Security: PAP
  • Splash Page: *insert access_url here*
  • Landing Page: Enabled (ticked)
  • Landing Page URL: *insert redirect_url here*
  • Profile MAC Address: LAN MAC Address
  • Allowed Domains / IPs: Enter the required domains one per line. Please refer to this list.
Under RADIUS Server Settings (Primary Server):
  • Host: *insert radius_server_ip here*
  • Secret: *insert radius_secret here*
  • Authentication Port: 1812
  • Accounting Port: 1813

 

Under RADIUS Server Settings (Secondary Server):

  • Host: *insert radius_server2_ip here*
  • Secret: *insert radius_secret here*
  • Authentication Port: 1812
  • Accounting Port: 1813
Under Guest Protect:
  • Block LAN Access: Enabled (ticked)
Click Save to confirm.

 

At the top right, click Apply Changes to complete.

Compartir en línea
¿Fue útil este artículo?
Usuarios a los que les pareció útil: 0 de 0